無菌室裝修的工作規程

無菌室裝修的工作規程

返回列表 來源：發布日期： 2020.11.19

1、無菌室滅菌。每次使用前開啟紫外線燈照射30min以上，或在使用前30min，對內外室用5%石炭酸噴霧。
1 、 sterilization in asepsis room. Before each use open above UV lamp 30min, or prior to use 30min on the inside and outside room 5% carbolic spray.
2、用肥皂洗手後，把所需器材搬入外室；在外室換上已滅菌的工作服、工作帽和工作鞋，戴好口罩，然後用2%煤酚皂液將手浸洗2分鍾。

2, after washing with soap, the equipment needed to move into the outer chamber; in the outer room for sterilized working clothes, hats and shoes, wearing masks, and then use the 2% Lysol liquid dip hands for 2 minutes.

3、將各種需用物品搬進內室清點、就位，用5%石炭酸在工作台麵上方和操作員站位空間噴霧，返回外室，5～10min後再進內室工作。

3, all kinds of necessities into check and chamber in place, with 5% in the working table and carbolic spray operator station space, return to the outer chamber, 5 ~ 10min after work into the chamber.
4、接種操作前，用70%酒精棉球擦手；進行無菌操作時，動作要輕緩，盡量減少空氣波動和地麵揚塵。
4, before inoculation, use 70% alcohol cotton ball to wipe hands; for aseptic operation, the action should be light and slow, as far as possible to reduce air fluctuation and ground dust.
5、工作中應注意安全。如遇棉塞著火，用手緊握或用濕布包裹熄滅，切勿用嘴吹，以免擴大燃燒；如遇有菌培養物灑落或打碎有菌容器時，應用浸潤5%石炭酸的抹布包裹後，並用浸潤5%石炭酸的抹布擦拭台麵或地麵，用酒精棉球擦手後再繼續操作。
5, work should pay attention to safety. In the case of cotton plug ignition, by hand or with a damp cloth wrapped out, do not blow through your mouth, in order to avoid the expansion of combustion; if there is a bacteria culture on bacteria or break the container, use carbolic cloth infiltration in 5% packages, and wipe with a cloth or table 5% carbolic infiltration ground, with rubbing alcohol hand before proceeding.
6、工作結束，立即將台麵收拾幹淨，將不應在無菌室存放的物品和廢棄物全部拿出無菌室後，對無菌室用5%石炭酸噴霧，或開紫外線燈照射30min。

6, the work is over, immediately clean up the table, will not be stored in the asepsis room of the goods and waste all out of the asepsis room, the asepsis room with 5% carbolic spray, or ultraviolet light irradiation 30min.

昆山昌瑞空調淨化技術有限公司，專注從事空氣過濾器係列產品（初/中/高效、化學過濾器等）、潔淨室淨化設備（拋棄式/可更換式/自動卷繞式過濾器、高效送風口、FFU高效過濾器淨化機組）的研發、生產、銷售和售後。

Changrui Air Conditioning Purification Technology Co., Ltd. focuses on the R&D, production, sales and after-sales of air filter series products (primary/medium/high-efficiency, chemical filters, etc.) and clean room purification equipment (disposable/replaceable/automatic winding filters, high-efficiency air supply outlets, FFU high-efficiency filter purification units).